Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P17A7    Transfer Synchronization Actuator Circuit High

for Preparation Click here


DESCRIPTION

This DTC is detected when a short to B+ is detected in the solenoid coil drive circuit.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P17A7
  1. Ignition switch ON (when not switching between 2WD and 4H)
  2. Short to B+ in the solenoid coil drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. Solenoid coil sub-assembly
  4. Transfer shift actuator assembly

WIRING DIAGRAM

Refer to DTCs P17A5 and P17A6 .

INSPECTION PROCEDURE

1.CHECK SOLENOID COIL SUB-ASSEMBLY
E116654E19
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-6 (SCC) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
Go to step 2
OK

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
  1. Disconnect the A26 4 wheel drive control ECU connector.

  1. Disconnect the D67 transfer shift actuator assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-6 (SCC) or D67-3 (SCC) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT SOLENOID COIL SUB-ASSEMBLY
C295407E01
  1. Disconnect the A solenoid coil sub-assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    2 - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Component without harness connected
    (Solenoid Coil Sub-assembly)



NG
REPLACE SOLENOID COIL SUB-ASSEMBLY (Click here)
OK

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY (Click here)