Home › Engine / Hybrid System › 1UR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27M0U _51 Engine / Hybrid System _049093 1UR-FE ENGINE CONTROL _0233901 HEATED OXYGEN SENSOR A

1UR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

The procedures should be performed by at least 2 people.

·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 37117 1.REMOVE PROPELLER SHAFT HEAT INSULATOR

Hide 89465 2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.

Disconnect the heated oxygen sensor connector.


b.
A215444E02
1.667,0.521 1.823,0.521 1.823,0.521 2.156,0.958 true 1.292,0.458 1.646,0.635 0.354,0.177 10 true SST

Using SST, remove the heated oxygen sensor.

SST
09224-00010  


Hide 89465 3.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A215447E02
2.344,0.677 2.135,0.688 2.135,0.688 1.771,0.969 true 2.406,0.594 2.885,0.792 0.479,0.198 10 true SST

Detach the 2 clamps and disconnect the heated oxygen sensor connector.


b.

Using SST, remove the heated oxygen sensor.

SST
09224-00010