Home › Engine / Hybrid System › 1UR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM27M0U _51 Engine / Hybrid System _049093 1UR-FE ENGINE CONTROL _0233906 POWER STEERING OIL PRESSURE SWITCH G

1UR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the oil pressure switch.

i.

Connect the Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the Techstream main switch on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering pressure.


v.

Start the engine.


vi.

Operate the steering wheel while idling, and read the value on the Techstream.

Standard:
Measurement Condition Specified Condition
Power steering not operating 0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi)
Power steering operating Values change from above value


If not as specified, check for DTCs (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

Inspect the power steering system (See page Steering>POWER STEERING>POWER STEERING SYSTEM(for 1UR-FE)>ON-VEHICLE INSPECTION). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.