INITIALIZATION
Perform Reset Memory (AT initialization) for 2WD when replacing the automatic transmission assembly, engine assembly or ECM (See page Drivetrain>A760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).
Perform Reset Memory (AT initialization) for 4WD when replacing the automatic transmission assembly, engine assembly or ECM (See page Drivetrain>A760F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).
Perform Registration (VIN registration) when replacing the ECM (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION).
Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
The engine learned value cannot be reset by disconnecting the battery negative (-) terminal or removing the EFI NO. 1 and ETCS fuses.
WHEN USING TECHSTREAM
Observe the following items for safety reasons:
Read the Techstream instruction books before using the Techstream.
Make sure that the Techstream cable is not caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
When driving the vehicle for testing purposes using the Techstream, two persons are required. One drives the vehicle and the other operates the Techstream.