This circuit opens and closes the Intake Air Control Valve (IACV) in response to the engine load in order to increase the intake efficiency (ACIS: Acoustic Control Induction System).
Disconnect the vacuum hose from port F on the vacuum switching valve (for ACIS).
Connect the Techstream to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.
Operate the VSV for ACIS.
Check the VSV air flow when switching the VSV.
| Test Condition | Specified Condition |
|---|---|
| VSV is ON | Air from port E flows out through port F |
| VSV is OFF | Air from port E flows out through air filter |
OK
NG
OK
NG
Inspect the intake air control valve (See page Engine / Hybrid System>3UR-FE INTAKE>INTAKE SYSTEM>ON-VEHICLE INSPECTION).
OK
NG
Inspect the vacuum switching valve (See page Engine / Hybrid System>3UR-FE INTAKE>VACUUM SWITCHING VALVE(for ACIS)>ON-VEHICLE INSPECTION).
OK
NG
Remove the EFI NO. 2 fuse from the engine room relay block.
Check the EFI NO. 2 fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| EFI NO. 2 fuse | Always | Below 1 Ω |
Reinstall the EFI NO. 2 fuse.
Disconnect the D62 intake air control valve connector.
Disconnect the D74 ECM connector.
Remove the integration relay from the engine room relay block (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>EFI RELAY>ON-VEHICLE INSPECTION).
Disconnect the 1B integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D62-2 - D74-62 (ACIS) | Always | Below 1 Ω |
| D62-1 - 1B-4 | Always | Below 1 Ω |
| D62-2 or D74-62 (ACIS) - Body ground | Always | 10 kΩ or higher |
| D62-1 or 1B-4 - Body ground | Always | 10 kΩ or higher |
OK
NG