Perform "Inspection After Repairs" after replacing the fuel injector (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Perform "Inspection After Repairs" after replacing the fuel injector (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
Attach the 3 clamps to install the No. 6 wire harness to the delivery pipe RH.
Attach the 3 clamps to install the No. 7 wire harness to the delivery pipe LH.
Apply gasoline or spindle oil to a new O-ring and install it to the injector.
Make sure that there is no damage or foreign material in the groove of the injector when installing the O-ring.
Connect the injector connector.
Install the injector to the delivery pipe as shown in the illustration.
Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
When inserting the injector, be careful not to damage the O-ring.
Attach the part of the injector labeled B between the parts of the delivery pipe labeled A.
Check that each injector is installed to the delivery pipe facing the direction shown in the illustration.
23807
2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY LH
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head LH.
Install the delivery pipe (with injectors) to the cylinder head LH.
Install the 2 bolts.
Make sure that the part of the injector labeled B is between the parts of the delivery pipe labeled A.
Connect the No. 7 wire harness connector.
Install the No. 1 engine cover.
23808
3.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY RH
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head RH.
Install the delivery pipe (with injectors) to the cylinder head RH.
Install the 2 bolts.
Make sure that the part of the injector labeled B is between the parts of the delivery pipe labeled A.
Install the No. 3 engine cover.
Connect the No. 6 wire harness connector.
Connect the ventilation hose.
23801P
4.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Connect the No. 1 fuel pipe to the fuel delivery pipe LH (for quick type B) (see page Engine / Hybrid System>3UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Attach the clamp.
23901
5.CONNECT FUEL TUBE SUB-ASSEMBLY
Connect the fuel tube to the delivery pipe LH (for quick type A) (see page Engine / Hybrid System>3UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the fuel tube to the fuel delivery pipe RH (for quick type A) (see page Engine / Hybrid System>3UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
23902
6.CONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Connect the No. 2 fuel tube to the fuel pressure regulator (for quick type A) (see page Engine / Hybrid System>3UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
17880
7.INSTALL AIR CLEANER HOSE ASSEMBLY
11209
8.INSTALL V-BANK COVER
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10.CHECK FOR FUEL LEAK
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream main switch on.
Do not start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.