35000
1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
for 2WD:
Remove the automatic transmission (See page Drivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>REMOVAL).
for 4WD:
Remove the automatic transmission (See page Drivetrain>AB60F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>REMOVAL).
32101
2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
11381A
3.REMOVE REAR CRANKSHAFT OIL SEAL
Using a knife, cut off the lip of the oil seal.
Using a screwdriver, pry out the oil seal.
Tape the screwdriver tip before use.
Do not damage the surface of the oil seal press fit hole and crankshaft.