Home › Engine / Hybrid System › 3UR-FE ENGINE MECHANICAL › DRIVE BELT
RM27M0U _51 Engine / Hybrid System _049106 3UR-FE ENGINE MECHANICAL _0234020 DRIVE BELT A

3UR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN & GENERATOR V BELT

a.
A163771E07
0.385,0.594 0.177,0.594 0.177,0.594 0.313,1.51 false 1.948,0.156 1.781,0.156 1.781,0.156 1.458,1.031 false 2.677,0.615 2.823,0.615 2.823,0.615 2.719,1 false 0.906,2.375 1.073,2.677 1.073,2.677 0.906,2.677 false 1.063,1.896 1.375,3.01 1.375,3.01 1.198,3.01 false 1.823,2.479 1.698,3.083 false 2.917,2.458 2.583,2.688 false 2,0.083 2.833,0.271 0.833,0.188 10 false Water Pump 0.448,0.521 1.208,0.719 0.76,0.198 10 false Vane Pump 2.031,2.708 3.281,2.875 1.25,0.167 10 false Cooler Compressor 0.271,2.573 0.938,2.74 0.667,0.167 10 false Generator 2.156,1.208 2.448,1.375 0.292,0.167 10 false Fan 1.365,3.094 2.094,3.281 0.729,0.188 10 false Crankshaft 0.271,2.917 1.198,3.083 0.927,0.167 10 false Belt Tensioner 1.979,0.542 2.677,0.688 0.698,0.146 10 false No. 1 Idler

Set the V belt onto every part.


b.

While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:

Make sure that the V belt is properly set to each pulley.



c.
A174124E01
0.231,1.304 1.012,1.497 0.781,0.193 10 CORRECT 1.911,1.304 2.817,1.465 0.906,0.161 10 INCORRECT

After installing the belt, check that it fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.