Home › Engine / Hybrid System › 1UR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM27M0U _51 Engine / Hybrid System _049107 1UR-FE ENGINE MECHANICAL _0234041 REAR CRANKSHAFT OIL SEAL A

1UR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 35000 3.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

Hide 32101 4.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 11381A 5.REMOVE REAR CRANKSHAFT OIL SEAL

a.

Using a knife, cut off the lip of the oil seal.


b.
A214559E01
0.059,1.568 0.854,1.751 0.795,0.184 10 Cut Position

Using a screwdriver, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.


HINT:

Tape the screwdriver tip before use.