Home › Drivetrain › A760F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION ASSEMBLY
RM27M0U _52 Drivetrain _049127 A760F AUTOMATIC TRANSMISSION / TRANSAXLE _0234160 AUTOMATIC TRANSMISSION ASSEMBLY A

A760F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 37140 6.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 37110 7.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 17410 8.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 33820B 9.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C155905

a.

Remove the nut and clip, and disconnect the transmission control cable.


Hide 32101A 11.REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT

A215546

a.

Remove the flywheel housing side cover.


b.
C161354

Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.


Hide 35000 12.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

C159641

a.

Support the transmission with a transmission jack. Lift the transmission slightly from the crossmember.


Hide 51204 13.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

C157036

a.

Remove the 4 bolts of the rear engine mounting insulator.


b.
C157035

Remove the 4 nuts, 4 washers, 4 bolts and frame crossmember.


Hide 12371 14.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

C157037

a.

Remove the 4 bolts and rear engine mounting insulator from the transmission.


Hide 15.DISCONNECT WIRE HARNESS AND CONNECTOR

C155915

a.

Remove the bolt and disconnect the ground cable.


b.
C157274

Tilt the transmission downward.

NOTICE:

Make sure the cooling fan does not contact the fan shroud.



c.

Disconnect the park/neutral position switch connector, transmission wire connector, 2 transmission speed sensor connectors and 3 transfer control side connectors.

U152427

HINT:

Detach the claw, press down the lever, and then disconnect the transmission wire connector.



d.

Detach the 4 connector clamps and 8 harness clamps.


e.

Remove the bolt, disconnect the harness clamp and wire harness.


Hide 33490F 17.REMOVE TRANSMISSION OIL COOLER ASSEMBLY

Hide 35000 18.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

C209682

a.

Remove the 10 bolts and transmission.

NOTICE:

Do not use excess force when prying the transmission assembly.



Hide 19.REMOVE HARNESS CLAMP BRACKET

C210207

a.

Remove the 5 bolts and 5 brackets.


Hide 33823A 20.REMOVE TRANSMISSION CONTROL CABLE BRACKET

C159643

a.

Remove the 2 bolts and bracket.


Hide 36100 21.REMOVE TRANSFER ASSEMBLY

Hide 32000 22.REMOVE TORQUE CONVERTER ASSEMBLY

a.

Remove the torque converter assembly from the automatic transmission assembly.

NOTICE:

Remove the torque converter assembly from the input shaft horizontally.