If an exhaust gas leak has been repaired, perform an inspection following the repair (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
89467B
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
17450B
2.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
Connect the front No. 2 exhaust pipe assembly to the exhaust pipe support.
Install a new gasket and the front No. 2 exhaust pipe assembly to the exhaust manifold LH with 3 new nuts.
89467B
3.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
17410
4.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold with 3 new nuts.
17420
5.INSTALL CENTER EXHAUST PIPE ASSEMBLY
Connect the center exhaust pipe assembly to the 3 exhaust pipe supports.
Install 2 new gaskets to the front exhaust pipe assembly and front No. 2 exhaust pipe assembly.
Install the center exhaust pipe assembly with the 4 bolts.
17430
6.INSTALL TAILPIPE ASSEMBLY
Connect the tailpipe assembly to the exhaust pipe support.
Install a new gasket to the center exhaust pipe assembly.
Attach a new clamp to the tailpipe assembly and center exhaust pipe assembly. Then install the bolt to the clamp.
Install the clamp within the angle range shown in the illustration.
| *a | Top |
| *b | LH Side of Vehicle |
| *c | Front Side of Vehicle |
89465
7.INSTALL HEATED OXYGEN SENSOR
8.INSPECT FOR EXHAUST GAS LEAK
If an exhaust gas leak has been repaired, perform an inspection following the repair (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.