Home › Engine / Hybrid System › 3UR-FBE EXHAUST › EXHAUST PIPE
RM27M0U _51 Engine / Hybrid System _049110 3UR-FBE EXHAUST _0234049 EXHAUST PIPE A

3UR-FBE EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 17430 1.REMOVE TAILPIPE ASSEMBLY

a.

Remove the bolt and clamp.


b.

Disconnect the exhaust pipe support to remove the tailpipe assembly.


c.

Remove the gasket.


Hide 17420 2.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 4 bolts.


b.

Disconnect the 3 exhaust pipe supports to remove the center exhaust pipe assembly.


c.

Remove the 2 gaskets.


Hide 37140 3.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 17450B 4.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Remove the 3 nuts.


b.

Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly.


c.

Remove the gasket.


Hide 89467B 5.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

Hide 89465 6.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Remove the 3 nuts and front exhaust pipe assembly.


b.

Remove the gasket.


Hide 89467B 8.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

Hide 89465 9.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)