Home › Engine / Hybrid System › 1UR-FE COOLING › THERMOSTAT
RM27M0U _51 Engine / Hybrid System _049113 1UR-FE COOLING _0234065 THERMOSTAT A

1UR-FE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.


PROCEDURE

Hide 5.REMOVE AIR TUBE SUB-ASSEMBLY LH

a.
A215879

Disconnect the 2 connectors.


b.

Disconnect the water by-pass hose.


c.
A215282

Disconnect the 2 wire harness clamps and air hose.


d.

Remove the bolt and disconnect the air tube LH from the water inlet housing.


e.
A215284

Disconnect the vacuum sensor connector and clamp.


f.

Remove the 2 bolts and disconnect the air hose from the air switching valve LH.


g.

Remove the air tube LH.


Hide 16572 6.DISCONNECT OUTLET RADIATOR HOSE

a.
A215882

Disconnect the radiator hose.


Hide 16031 7.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

a.
A215881

Remove the 3 nuts, water inlet with thermostat and gasket.