Home › Engine / Hybrid System › 3UR-FBE LUBRICATION › ENGINE OIL COOLER
RM27M0U _51 Engine / Hybrid System _049116 3UR-FBE LUBRICATION _0234081 ENGINE OIL COOLER A

3UR-FBE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15788 1.INSTALL OIL COOLER SPACER

a.
A162474E01
2.716,0.391 3.223,0.557 0.508,0.166 10 Gasket 2.687,0.48 2.623,0.48 false 2.623,0.48 2.211,0.79 false

Apply a light coat of engine oil to a new gasket.


b.

Install the gasket to the oil cooler spacer.


c.
A162472

Install the oil cooler spacer to the oil filter bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 15710 2.INSTALL OIL COOLER ASSEMBLY

a.
A162475

Apply a light coat of engine oil to 2 new O-rings.


b.

Install the 2 O-rings to the oil cooler.


c.
A162471

Install the oil cooler with the 5 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 15671 3.INSTALL OIL FILTER BRACKET

a.
A162470

Apply a light coat of engine oil to 2 new O-rings.


b.

Install the 2 O-rings to the timing chain cover.


c.
A162469

Install the oil filter bracket with the 2 nuts and 2 bolts.

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)


Hide 15781 4.INSTALL NO. 1 OIL COOLER BRACKET

a.
A163672

Connect the ground wire to the cylinder block.


b.

Install the oil cooler bracket with the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 16268A 5.INSTALL NO. 2 WATER BY-PASS PIPE

a.
A162468

Connect the 4 hoses.


b.

Install the water by-pass hose with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88320 6.CONNECT COOLER COMPRESSOR ASSEMBLY

Hide 83520 7.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 8.INSTALL OIL FILTER ELEMENT

Hide 16361A 9.INSTALL FAN & GENERATOR V BELT

a.

Install the fan and generator V belt (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).


Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL