Home › Engine / Hybrid System › 3UR-FBE LUBRICATION › ENGINE OIL COOLER
RM27M0U _51 Engine / Hybrid System _049116 3UR-FBE LUBRICATION _0234081 ENGINE OIL COOLER A

3UR-FBE LUBRICATION  ENGINE OIL COOLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 16361A 5.REMOVE FAN & GENERATOR V BELT

a.

Remove the fan and generator V belt (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>DRIVE BELT>REMOVAL)


Hide 6.REMOVE OIL FILTER ELEMENT

Hide 83520 7.REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 88320 8.DISCONNECT COOLER COMPRESSOR ASSEMBLY

Hide 16268A 9.REMOVE NO. 2 WATER BY-PASS PIPE

a.
A162468

Remove the 3 bolts.


b.

Remove the 4 hoses and water by-pass pipe.


Hide 15781 10.REMOVE NO. 1 OIL COOLER BRACKET

a.
A163672

Remove the 2 nuts and bracket.


b.

Disconnect the ground wire from the cylinder block.


Hide 15671 11.REMOVE OIL FILTER BRACKET

a.
A162469

Remove the 2 bolts, 2 nuts and filter bracket.


b.
A162470

Remove the 2 O-rings.


Hide 15710 12.REMOVE OIL COOLER ASSEMBLY

a.
A162471

Remove the 5 nuts and oil cooler from the oil filter bracket.


b.
A162475

Remove the 2 O-rings.


Hide 15788 13.REMOVE OIL COOLER SPACER

a.
A162472

Remove the bolt and oil cooler spacer from the oil filter bracket.


b.
A162474E01
2.716,0.391 3.223,0.557 0.508,0.166 10 Gasket 2.687,0.48 2.623,0.48 false 2.623,0.48 2.211,0.79 false

Remove the gasket.