Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234088 TIRE PRESSURE WARNING SYSTEM C

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  C2176/76  Receiver Error  


DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC Code DTC Detection Condition Trouble Area
C2176/76 Malfunction in the tire pressure warning ECU internal circuit. Tire pressure warning ECU

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.

·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.



PROCEDURE

1.CLEAR DTC

b.

Turn the ignition switch off.



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Check for DTC.

Result
Result Proceed to
DTC C2176 is output A
DTC C2176 is not output B



A

REPLACE TIRE PRESSURE WARNING ECU

B