Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234091 TIRE PRESSURE WARNING ECU A

TIRE AND WHEEL  TIRE PRESSURE WARNING ECU  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the intelligent tester or Techstream and write them down before removal.



PROCEDURE

Hide 55045A 1.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 3.REMOVE TIRE PRESSURE WARNING ECU

a.
C295013

Remove the 2 nuts and tire pressure warning ECU.

NOTICE:
·

Avoid any impact to the tire pressure warning ECU.

·

Do not drop the tire pressure warning ECU. If it is dropped, replace it with a new one.