Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234088 TIRE PRESSURE WARNING SYSTEM D

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  TEST MODE PROCEDURE  


TEST MODE PROCEDURE


HINT:
·

Operation of the tire pressure warning reset switch can be checked in Test Mode.

·

During Test Mode, the system is not initialized by pushing the tire pressure warning reset switch. The circuit of the tire pressure warning reset switch can be inspected during this mode.



a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Check that the tire pressure warning light turns on for 3 seconds and then goes off.


e.

Turn the Techstream on.


f.

Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.


g.
F100632E16
1.125,0.438 1.875,0.625 0.75,0.188 10 false 0.125 sec. 0.719,1.573 1.427,1.771 0.708,0.198 10 false 0.125 sec. 0.104,0.875 0.354,1.042 0.25,0.167 10 false ON 0.063,1.177 0.385,1.333 0.323,0.156 10 false OFF

Confirm that the tire pressure warning light in the combination meter blinks at 0.125 second intervals.



PERFORM SIGNAL CHECK


HINT:
·

When entering Signal Check mode, the tire pressure warning ECU stores all the Test Mode DTCs first.

After completing the signal check for each inspection item, the DTCs for systems that are determined to be normal by the tire pressure warning ECU will be cleared.

The DTCs for other inspection items may not be cleared when only a certain signal is inspected.

·

When signal check returns to normal mode, all the Test Mode DTCs will be cleared.



a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON and the Techstream on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.

HINT:

Every time the Test Mode DTC clear conditions are satisfied, the tire pressure warning light turns on for 1 second. Then, the tire pressure warning light blinks at 0.125 second intervals.



e.

Drive the vehicle at 20 km/h (12 mph) or more for 3 seconds or more to check the vehicle speed signal (C2191/91).


f.

Loosen the valve core and rapidly reduce the pressure (at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds) to check the transmitter data (C2181/81 to C2184/84).

HINT:

The transmitter ID can be transmitted by rapidly reducing the tire pressure.



g.

Check that the tire pressure warning system Test Mode DTCs are cleared.

Test Mode DTC Test Signal Test Mode DTC Clear Condition
C2181/81 to C2184/84 Transmitter Data Receive data from the transmitter which has a registered ID in the tire pressure warning ECU
C2191/91 Vehicle Speed Signal Vehicle speed of 20 km/h (12 mph) or more is detected for 3 seconds or more


h.

Check the tire pressure warning reset switch.

i.

Press the tire pressure warning reset switch.


ii.

Check the tire pressure warning light.

Test Signal Normal Condition
Tire Pressure Warning Reset Switch
·

Switch ON: Tire pressure warning light turns on.

·

Switch OFF: Tire pressure warning light blinks at 0.125 second intervals.





i.

Result

HINT:

After the signal check is completed, check for a Test Mode DTC to confirm the system status.


Condition Procedure
Test Mode DTC is output Repair the faulty part and enter Signal Check again
Test Mode DTCs are cleared No problem


j.

End of Signal Check

i.

After completing the Test Mode (Signal Check), turn the ignition switch off and disconnect the Techstream.



k.

DTC of Signal Check (Test Diagnosis)

i.

If a trouble code is displayed during the Test Mode DTC check, check the circuit listed for that code. For details of each code, refer to the "See page" below.

DTC Code Detection Item Trouble Area See page
C2181/81 Transmitter ID1 not received
·

Tire pressure warning valve and transmitter

·

Tire pressure warning antenna and receiver

·

Wire harness or connector

·

Tire pressure warning ECU


(Click here)
C2182/82 Transmitter ID2 not received
·

Tire pressure warning valve and transmitter

·

Tire pressure warning antenna and receiver

·

Wire harness or connector

·

Tire pressure warning ECU


(Click here)
C2183/83 Transmitter ID3 not received
·

Tire pressure warning valve and transmitter

·

Tire pressure warning antenna and receiver

·

Wire harness or connector

·

Tire pressure warning ECU


(Click here)
C2184/84 Transmitter ID4 not received
·

Tire pressure warning valve and transmitter

·

Tire pressure warning antenna and receiver

·

Wire harness or connector

·

Tire pressure warning ECU


(Click here)
C2191/91 Vehicle speed signal error
·

Combination meter

·

Wire harness or connector

·

Vehicle speed signal circuit

·

Tire pressure warning ECU


(Click here)