Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234442 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55607 3.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55475A 8.REMOVE NO.2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55045A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 10.REMOVE CLEARANCE WARNING ECU WITH BRACKET

a.
B354801

Disconnect the ECU connectors and detach the harness clamp.

NOTICE:

Do not apply excessive force to the wire harnesses.



b.

Remove the bolt, nut and clearance warning ECU with bracket.


Hide 89340A 11.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.
B354802

Remove the 2 nuts and clearance warning ECU assembly from the bracket.

NOTICE:
·

Avoid any impact to the clearance warning ECU assembly.

·

Do not drop the ECU. If it is dropped, replace it with a new one.