Home › Drivetrain › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234104 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

WF1AM TRANSFER  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is detected if communication is lost between the ECM and skid control ECU.

DTC Code DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0100
1.

Ignition switch ON

2.

Communication is lost between ECM and 4 wheel drive control ECU

3.

5 seconds or more

4.

1 trip detection logic


CAN communication system
U0122
1.

Ignition switch ON

2.

Communication is lost between skid control ECU and 4 wheel drive control ECU

3.

0.7 seconds or more

4.

1 trip detection logic


CAN communication system

CAUTION / NOTICE / HINT

NOTICE:
·

When the data in the ECM or skid control ECU is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

·

Clear all DTCs, since DTCs are stored after the data in the ECM or skid control ECU is overwritten.



PROCEDURE

1.RECONFIRM DTC

b.

Check if the same DTCs are output (See page Drivetrain>WF1AM TRANSFER>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B