Home › Brake › BRAKE › BRAKE BOOSTER
RM27M0U _54 Brake _049123 BRAKE _0234117 BRAKE BOOSTER A

BRAKE  BRAKE BOOSTER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from the booster by depressing the brake pedal several times. then remove the brake master cylinder sub-assembly from the brake booster assembly.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 47201 4.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Remove the brake master cylinder (See page Brake>BRAKE>BRAKE MASTER CYLINDER>REMOVAL).


Hide 44773F 5.DISCONNECT VACUUM HOSE ASSEMBLY

a.

Slide the clip and disconnect the vacuum hose from the check valve.


Hide 6.DISCONNECT BRAKE BOOSTER CONNECTOR

a.

Disconnect the 2 brake booster connectors from the brake booster.


Hide 73900 7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Remove the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>DRIVER SIDE KNEE AIRBAG ASSEMBLY>REMOVAL).


Hide 47264A 8.REMOVE PUSH ROD PIN

a.

Remove the clip and push rod pin.


Hide 44610 9.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C208550

Remove the 4 nuts, and then pull out the brake booster.


b.

Remove the brake booster gasket from the brake booster.


c.

Loosen the lock nut and then remove the clevis.


Hide 44730 10.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY