33550
1.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
Temporarily install the transmission floor shift assembly to the body with the 4 bolts.
Fully tighten the 4 bolts in the order shown in the illustration.
Connect the clamp and 2 connectors.
Install the cable outer of the transmission control cable assembly to the shift lever retainer, and then install a new clip.
Connect the control cable end to the shift lever assembly.
| *1 | Ridged |
Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable ridged side of the cable end is facing upward.
Connect the 2 connectors.
58861C
2.INSTALL NO. 1 CONSOLE BOX DUCT (w/ Rear Air Duct)
Install the No. 1 console box duct with the 2 clips.
3.ADJUST SHIFT LEVER POSITION
4.INSPECT SHIFT LEVER POSITION
5.INSTALL CONSOLE BOX ASSEMBLY