Home › Drivetrain › A760F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE(for Floor Shift Type)
RM27M0U _52 Drivetrain _049127 A760F AUTOMATIC TRANSMISSION / TRANSAXLE _0234171 TRANSMISSION CONTROL CABLE(for Floor Shift Type) A

A760F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE(for Floor Shift Type)  INSTALLATION  


PROCEDURE

Hide 33820B 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

C157286

a.

Insert the transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.
U152174

Connect the transmission control cable to the shift lever retainer, and install a new clip.


c.
U152184E02
2.229,0.552 1.792,0.26 true 1,0.146 1.833,0.344 0.833,0.198 10 false Ridged Side

Connect the control cable end to the shift lever.

NOTICE:

Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.



d.

Move the shift lever to N.


e.
C155873E02
1.906,0.052 2.052,0.219 0.146,0.167 10 false N 1.021,0.271 1.146,0.438 0.125,0.167 10 false P 1.573,0.292 1.719,0.458 0.146,0.167 10 false R

Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.


f.
U152182E02
2.573,0.708 1.438,0.948 false 0.906,0.854 1.438,1.021 0.531,0.167 10 false Bracket 0.99,0.167 2.021,0.458 1.031,0.292 10 true Inside of Vehicle

Connect the control cable with a new clip and the nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

When connecting the cable to the transmission control shaft lever, make sure the L bracket of the cable faces the inside of the vehicle.



g.
C157285

Connect the transmission control cable support with the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)