Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
RM27M0U _55 Steering _049129 STEERING COLUMN _0234195 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2621  Communication Interruption  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU detects the connection of each ECU based on the signal.

DTC Code Detection Condition Trouble Area
B2621 The periodic signal from a specified ECU has stopped.
·

CAN communication system

·

Main body ECU

·

Front power seat control ECU and switch LH

·

Combination meter

·

Multiplex tilt and telescopic ECU



PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Check for DTCs of the CAN communication system (see page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>PRECAUTION).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.READ VALUE USING TECHSTREAM (MAIN BODY ECU COMMUNICATION SIGNAL)

B

2.READ VALUE USING TECHSTREAM (MAIN BODY ECU COMMUNICATION SIGNAL)
a.

Use the Data List to check if the main body ECU communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
J/B Communication state of main body ECU signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-

OK:

"OK" is displayed.




OK

3.READ VALUE USING TECHSTREAM (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL)

NG

REPLACE MAIN BODY ECU

3.READ VALUE USING TECHSTREAM (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL)
a.

Use the Data List to check if the front power seat control ECU and switch LH communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Receive from Seat ECU Communication state of front power seat control ECU and switch LH signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-

OK:

"OK" is displayed.




OK

4.READ VALUE USING TECHSTREAM (COMBINATION METER ECU COMMUNICATION SIGNAL)

NG

REPLACE FRONT POWER SEAT CONTROL ECU AND SWITCH LH (DRIVER SEAT ECU)

4.READ VALUE USING TECHSTREAM (COMBINATION METER ECU COMMUNICATION SIGNAL)
a.

Use the Data List to check if the combination meter ECU communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Receive from Meter Communication state of combination meter signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-

OK:

"OK" is displayed.




OK

NG

REPLACE COMBINATION METER ASSEMBLY (COMBINATION METER ECU)