45286B
1.REMOVE UPPER STEERING COLUMN COVER
45287
2.REMOVE LOWER STEERING COLUMN COVER
3.INSPECT TILT MOTOR
Disconnect the connector A from the multiplex tilt and telescopic ECU.
| *a | Front view of wire harness connector:
(to Multiplex Tilt and Telescopic ECU) |
Connect the positive (+) battery terminal to terminal 10 (TIM+) and the negative battery terminal to terminal 1 (TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts up.
Steering wheel tilts up.
Connect the negative (-) battery terminal to terminal 10 (TIM+) and the positive battery terminal to terminal 1(TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts down.
Steering wheel tilts down.
4.INSPECT TELESCOPIC MOTOR
Disconnect the connector B from the multiplex tilt and telescopic ECU.
| *a | Front view of wire harness connector:
(to Multiplex Tilt and Telescopic ECU) |
Connect the positive battery terminal to terminal 2 (TEM+) and the negative battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column contracts.
Steering column contracts.
Connect the negative battery terminal to terminal 2 (TEM+) and the positive battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column extends.
Steering column extends.
45287
5.INSTALL LOWER STEERING COLUMN COVER
45286B
6.INSTALL UPPER STEERING COLUMN COVER