Home › Steering › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)
RM27M0U _55 Steering _049129 STEERING COLUMN _0234198 MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)  INSTALLATION  


PROCEDURE

Hide 89227 1.INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

a.
C159704

Install the ECU with the 2 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


b.

Connect the 2 ECU connectors.


Hide 73900 3.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55046A 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 45287 5.INSTALL LOWER STEERING COLUMN COVER

a.
C160536

Attach the 2 claws to install the steering column lower cover.


Hide 45286B 6.INSTALL UPPER STEERING COLUMN COVER

a.
C162097

Attach the claw to install the upper steering column cover.


b.

Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.


c.
C160535

Install the 2 screws.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)

HINT:

Turn the steering wheel to the right and left as necessary to install the 2 screws.



Hide 7.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable. some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)