1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.REMOVE FRONT WHEELS
3.REMOVE ENGINE ASSEMBLY
for 3UR-FBE:
Remove the engine assembly (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).
for 1UR-FE:
Remove the engine assembly (See page Engine / Hybrid System>1UR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).
for 3UR-FE:
Remove the engine assembly (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).
45203
4.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.
Remove the bolt and disconnect the No. 2 steering intermediate shaft from the power steering gear.
45047
5.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and nut.
Using SST, disconnect the tie rod end LH from the steering knuckle.
Hang SST with a string, etc. to prevent it from falling.
Do not damage the front disc brake dust cover.
Do not damage the ball joint dust cover.
Do not damage the steering knuckle.
45046
6.DISCONNECT TIE ROD END SUB-ASSEMBLY RH
Use the same procedures described for the LH side.
44410
7.DISCONNECT PRESSURE FEED TUBE ASSEMBLY
Using a union nut wrench, disconnect the pressure feed tube (return tube side) from the power steering gear.
Using a union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the power steering gear.
Remove the 2 bolts and disconnect the pressure feed tube clamp.
44250
8.REMOVE POWER STEERING GEAR ASSEMBLY
Remove the 2 bolts, 2 nuts and power steering gear.