Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY(for Floor Shift Type)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234211 CENTER AIRBAG SENSOR ASSEMBLY(for Floor Shift Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY(for Floor Shift Type)  INSTALLATION  


PROCEDURE

Hide 89170 1.INSTALL CENTER AIRBAG SENSOR ASSEMBLY

a.
B166503

Check that the ignition switch is OFF.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



c.

Install the airbag sensor with the 3 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the center airbag sensor.


e.

Connect the holder (with connectors).


f.

Check that the waterproof sheet is properly set.


Hide 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.CHECK SRS WARNING LIGHT