Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR(for Regular Cab)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234213 SIDE AIRBAG SENSOR(for Regular Cab) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Regular Cab)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SIDE AIRBAG SENSOR

a.
B165651

Check that the ignition switch is OFF.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation



c.

Install the door airbag sensor with the screw.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the door airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the door airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the side airbag sensor.


e.

Connect the connector.


Hide 67602 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side)

Hide 67492A 3.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side)

Hide 69260 4.INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side)

Hide 74232 5.INSTALL FRONT UPPER ARMREST BASE PANEL LH (for Front Side)

Hide 69284C 6.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side)

Hide 7.INSTALL REAR SIDE AIRBAG SENSOR

a.
B166507

Check that the ignition switch is OFF.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



c.

Install the side airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the side airbag sensor.


e.

Connect the connector.


Hide 67914 8.INSTALL FRONT DOOR SCUFF PLATE LH (for Rear Side)

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.CHECK SRS WARNING LIGHT