Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234218 CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax) A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax)  INSTALLATION  


PROCEDURE

Hide 62180A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

a.

Install the curtain shield airbag with the 10 bolts.

B169088

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)

NOTICE:

Do not twist the curtain shield airbag when installing it.



b.

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 63310 2.INSTALL ROOF HEADLINING ASSEMBLY

a.

Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for CrewMax) (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>INSTALLATION)


Hide 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.CHECK SRS WARNING LIGHT