Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234218 CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax) A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY(for CrewMax)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

HINT:

Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for CrewMax) (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>REMOVAL).


Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

a.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Remove the 10 bolts and curtain shield airbag.

B169088