When the ignition switch to ON, the occupant detection ECU sends a signal to the center airbag sensor assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The center airbag sensor assembly sends those signals to the combination meter assembly via CAN communication. The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter assembly in accordance with these signals.
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Clear the DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Occupant Detection / Data List.
Read the Data List according to the display on the Techstream (See page General>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Passenger Buckle SW | Front passenger buckle switch / Set, Unset or NG | Set: Seat belt fastened
Unset: Seat belt not fastened NG: Data is not determined |
- |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the Techstream screen according to the front passenger seat belt condition | A |
| Unset or Set is not displayed normally on the Techstream screen according to the front passenger seat belt condition | B |
| NG is displayed on the Techstream screen | C |
A
B
C
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the Techstream (See page General>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Passenger Buckle SW | Passenger buckle switch / Unset, Set or NG | Unset: Seat belt is not fastened
Set: Seat belt is fastened NG: Data is not determined |
- |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the Techstream screen according to the front passenger seat belt condition | A |
for Column Shift Type
·
Unset or Set is not displayed normally on the Techstream screen according to the front passenger seat belt condition ·
NG is displayed on the Techstream screen |
B |
for Floor Shift Type
·
Unset or Set is not displayed normally on the Techstream screen according to the front passenger seat belt condition ·
NG is displayed on the Techstream screen |
C |
A
B
C