Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM
RM27M0U _58 Vehicle Interior _049132 SEAT BELT _0234223 SEAT BELT WARNING SYSTEM Y

SEAT BELT  SEAT BELT WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the seat belt warning system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN system DTC, airbag system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.


Result:
Result Proceed to
DTC output does not reoccur A
CAN communication system DTC output reoccurs B
Airbag system DTC output reoccurs C
Occupant classification system DTC output reoccurs D



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

4.PROBLEM SYMPTOMS TABLE
a.

Result:
Proceed to
NEXT



NEXT

5.OVERALL ANALYSIS AND TROUBLESHOOTING*
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END