Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
73220
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
Align the vehicle's claws with the seat belt retractor positioning holes.
Install the front seat outer belt assembly LH with the 2 bolts.
First install bolt A, and then install bolt B.
Connect the pretensioner connector as shown in the illustration.
Insert the bolt and extension of the anti-rotation device through the quarter trim panel hole into the vehicle body.
Connect the front seat outer belt assembly LH with the bolt.
Attach the 2 claws to close the seat belt anchor cover.
62540
2.INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY LH (for LH Side)
Attach the 7 clips to install the lower quarter trim panel assembly LH.
Twist the front seat outer belt assembly LH clockwise and connect it with the bolt.
Attach the 2 claws to install the cover.
62530
3.INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY RH (for RH Side)
Attach the 9 clips to install the lower quarter trim panel assembly RH.
Install the jack assembly.
Install the trim cover.
Twist the front seat outer belt assembly RH counterclockwise and connect it with the bolt.
Attach the 2 claws to install the cover.
64429E
4.INSTALL LUGGAGE COMPARTMENT BOX RH
64439D
5.INSTALL LUGGAGE COMPARTMENT BOX LH
64261C
6.INSTALL UPPER BACK PANEL GARNISH
62312B
7.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
67914
8.INSTALL FRONT DOOR SCUFF PLATE LH
9.INSTALL FRONT SEAT ASSEMBLY
for Manual Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION)
for Power Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION)
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11.CHECK SRS WARNING LIGHT