Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3.REMOVE FRONT SEAT ASSEMBLY
for Manual Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL)
for Power Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL)
67914
4.REMOVE FRONT DOOR SCUFF PLATE LH
62312B
5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the front door opening trim weatherstrip so that the lower quarter trim panel assembly can be removed (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL).
64261C
6.REMOVE UPPER BACK PANEL GARNISH
64439D
7.REMOVE LUGGAGE COMPARTMENT BOX LH
64429E
8.REMOVE LUGGAGE COMPARTMENT BOX RH
62540
9.REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for LH Side)
Detach the 2 claws and remove the cover.
Loosen the bolt and disconnect the front seat outer belt assembly LH.
Detach the 7 clips and remove the quarter trim panel assembly LH.
62530
10.REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH (for RH Side)
Detach the 2 claws and remove the cover.
Loosen the bolt and disconnect the front seat outer belt assembly RH.
Push the 2 locks and remove the trim cover.
Remove the jack assembly.
Detach the 9 clips and remove the lower quarter trim panel assembly RH.
73220
11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Using a screwdriver, detach the 2 claws and open the shoulder belt anchor cover.
Tape the screwdriver tip before use.
Loosen the bolt and disconnect the front seat outer belt assembly LH.
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and front seat outer belt assembly LH.