Home › Vehicle Interior › INTERIOR › ROOF HEADLINING(for Regular Cab)
RM27M0U _58 Vehicle Interior _049165 INTERIOR _0234503 ROOF HEADLINING(for Regular Cab) A

INTERIOR  ROOF HEADLINING(for Regular Cab)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE FRONT SEAT ASSEMBLY (for Center Seat)

Hide 67914 5.REMOVE FRONT DOOR SCUFF PLATE LH

B165843

a.

Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.


Hide 67913 6.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 62111C 8.REMOVE COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure described for the LH side.


Hide 62312B 9.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.

Remove the front door opening trim weatherstrip LH.


Hide 62311B 10.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure described for the LH side.


Hide 64261C 11.REMOVE UPPER BACK PANEL GARNISH

B164740

a.

Detach the 10 clips and remove the upper back panel garnish.


Hide 64439D 12.REMOVE LUGGAGE COMPARTMENT BOX LH

B164747

a.

Remove the 2 clips.


b.

Detach the 3 claws and remove the luggage compartment box LH.


Hide 64429E 13.REMOVE LUGGAGE COMPARTMENT BOX RH

B164748

a.

Remove the 4 clips and luggage compartment box RH.


Hide 62540 16.REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH

B165729

a.

Detach the 2 claws and remove the cover.


b.
B165728

Loosen the bolt and disconnect the front seat outer belt assembly LH.


c.
B165710

Detach the 7 clips and remove the lower quarter trim panel assembly LH.


Hide 62530 17.REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH

B164750

a.

Detach the 2 claws and remove the cover.


b.
B164749

Loosen the bolt and disconnect the front seat outer belt assembly RH.


c.
B355510

Push the 2 locks and remove the trim cover.


d.

Remove the jack assembly.


e.
B355511

Detach the 9 clips and remove the lower quarter trim panel assembly RH.


Hide 62520P 18.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

a.
B355505E01
1.507,1.239 1.681,1.402 0.173,0.163 10 *1 1.709,1.326 2.21,1.326 2.21,1.326 2.21,0.955 false 1.948,1.326 1.948,1.105 false

Apply protective tape as shown in the illustration.

Text in Illustration
*1 Protective Tape


b.

Using a screwdriver, detach the claw and open the cover.

HINT:

Tape the screwdriver tip before use.



c.

Detach the 2 claws and open the shoulder belt anchor cover.


d.

Loosen the bolt and disconnect the front seat outer belt assembly LH.

B355508


e.
B355507

Remove the 2 bolts.


f.

Detach the 5 clips and remove the front quarter trim panel assembly LH.


Hide 62510P 19.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 63650A 20.REMOVE ROOF CONSOLE BOX ASSEMBLY

Hide 87834 21.REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)

Hide 74310 23.REMOVE VISOR ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 74631C 25.REMOVE COAT HOOK

a.
B355483E01
1.946,1.488 2.134,1.647 0.187,0.159 10 *1 2.14,1.583 2.325,1.583 2.325,1.583 2.455,1.179 false

Using a screwdriver, detach the 2 claws and remove the coat hook cap.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


b.
B355485

Using a T20 "TORX" driver, remove the "TORX" screw and coat hook.


Hide 63310 26.REMOVE ROOF HEADLINING ASSEMBLY

a.
B167283

w/ EC Mirror:

Disconnect the connector.


b.
B355487

Disconnect the connector and detach the 4 wire harness clamps from the front pillar LH.


c.
B355512

Detach the 3 clips and remove the roof headlining assembly.


d.
B355513

Take out the roof headlining assembly from the cabin as shown in the illustration.

NOTICE:

Be careful not to damage the roof headlining assembly when taking it out.