73240
1.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
for Manual Seat:
Install the front seat inner belt assembly LH with the nut.
Do not allow the anchor of the front seat inner belt assembly LH to overlap the protruding part of the separate type front seat cushion spring assembly.
| *1 | Protruding Part |
Attach the wire harness clamp.
Connect the connector and attach the connector clamp and 3 wire harness clamps.
| *1 | Connector Clamp |
| *2 | Wire Harness Clamp |
Attach the 2 hooks of the separate type front seat cushion cover.
for Power Seat:
Install the front seat inner belt assembly LH with the nut.
Do not allow the anchor of the front seat inner belt assembly LH to overlap the protruding part of the separate type front seat cushion spring assembly.
| *1 | Protruding Part |
Attach the wire harness clamp and connect the connector.
Attach the connector clamp and 3 wire harness clamps.
| *1 | Connector Clamp |
| *2 | Wire Harness Clamp |
73230
2.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
Install the front seat inner belt assembly RH with the nut.
Do not allow the anchor of the front seat inner belt assembly RH to overlap the protruding part of the separate type front seat cushion spring assembly.
| *1 | Protruding Part |
Connect the connector and attach the connector clamp.
71812D
3.INSTALL FRONT SEAT CUSHION SHIELD LH (for Manual Seat, for Driver Side)
72526
4.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat, for Driver Side)
5.INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
6.INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.CHECK SRS WARNING LIGHT