Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
73220
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Align the vehicle's claws with the seat belt retractor positioning holes.
Install the seat belt with the 2 bolts.
First install the bolt A, and then install bolt B.
Connect the pretensioner connector as shown in the illustration.
Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.
62412
2.INSTALL CENTER PILLAR GARNISH
62414A
3.INSTALL LOWER CENTER PILLAR GARNISH
Attach the 7 clips and 2 claws to install the pillar garnish.
Install the seat belt anchor with the bolt.
Attach the 2 claws to install the cover.
62312B
4.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
62332A
5.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
67914
6.INSTALL FRONT DOOR SCUFF PLATE
67918B
7.INSTALL REAR DOOR SCUFF PLATE
8.INSTALL FRONT SEAT ASSEMBLY
for Manual Seat:
Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).
for Power Seat:
Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).