Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab)
RM27M0U _58 Vehicle Interior _049132 SEAT BELT _0234229 FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 3.REMOVE FRONT SEAT ASSEMBLY

a.

for Manual Seat:

Remove the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).


b.

for Power Seat:

Remove the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).


Hide 62312B 6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL).


Hide 62332A 7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

a.

Partially remove the rear door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL).


Hide 62414A 8.REMOVE LOWER CENTER PILLAR GARNISH

B165827

a.

Detach the 2 claws and remove the cover.


b.
B165828

Remove the bolt and seat belt anchor.


c.
B165829

Detach the 7 clips and 2 claws, and remove the pillar garnish.


Hide 73220 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B166608

a.

Remove the nut and shoulder anchor.


b.
B166609

Disconnect the pretensioner connector as shown in the illustration.


c.
B166610

Remove the 2 bolts and seat belt.