Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3.REMOVE FRONT SEAT ASSEMBLY
for Manual Seat:
Remove the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
67914
4.REMOVE FRONT DOOR SCUFF PLATE
67918B
5.REMOVE REAR DOOR SCUFF PLATE
62312B
6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed.
62414A
7.REMOVE LOWER CENTER PILLAR GARNISH
Detach the 2 claws and remove the cover.
Remove the bolt and seat belt anchor.
Detach the 7 clips and 2 claws, and remove the pillar garnish.
62412
8.REMOVE CENTER PILLAR GARNISH
73220
9.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and shoulder anchor.
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and seat belt.