1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
84306
3.REMOVE SPIRAL CABLE SUB-ASSEMBLY
84650
4.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
5.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
Disconnect the connector.
While loosening the band clamp as shown in the illustration, detach the claw.
| *A | for Manual Tilt, for Manual Tilt and Manual Telescopic Steering Column | *B | for Power Tilt and Power Telescopic Steering Column |
Remove the headlight dimmer switch assembly.
If the claw is pressed forcefully, it will break.
| *A | for Manual Tilt, for Manual Tilt and Manual Telescopic Steering Column | *B | for Power Tilt and Power Telescopic Steering Column |