Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234292 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B15F8  D-Seat ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the position control ECU and switch assembly cannot be customized via the audio and visual system vehicle customization screen.

HINT:

The position control ECU and switch assembly controls the front power seat control system related items that are customizable via the radio and display receiver assembly screen.


DTC Code DTC Detection Condition Trouble Area
B15F8 Position control ECU and switch assembly vehicle setting processing error.
·

CAN communication system

·

Front power seat control system (w/ Memory)

·

Position control ECU and switch assembly

·

Radio and display receiver assembly



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the Techstream to check if the CAN communication system is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

OK:

CAN communication system DTCs are not output.




OK

2.CHECK FRONT POWER SEAT CONTROL SYSTEM

NG

2.CHECK FRONT POWER SEAT CONTROL SYSTEM
a.

Check if the front power seat control system is malfunctioning (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>HOW TO PROCEED WITH TROUBLESHOOTING).

HINT:

Customization may not be possible depending on the malfunction in the front power seat control system (w/ Memory).


OK:

No malfunctions are present in the front power seat control system (w/ Memory).




OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS
a.

Display the "Vehicle Customization" screen.


b.

Make a note of the customizable items for each position control ECU assembly related system.

HINT:

These items shown as customizable via the radio and display receiver assembly vehicle customization screen can also be changed using the Techstream. In a following step, the Techstream will be used.


i.

Check the customize parameters list for the front power seat control system (w/ Memory) related items that can be customized via the radio and display receiver assembly screen (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>CUSTOMIZE PARAMETERS).



c.

Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the radio and display receiver assembly screen.

OK:

The items available for customization via the radio and display receiver assembly screen can be customized successfully using the manual procedure.


Result
Result Proceed to
OK (for Column Shift Type) A
OK (for Floor Shift Type) B
NG C



A

B

C

REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY