Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
84922C
1.INSTALL FRONT POWER SEAT SWITCH LH
Install the front power seat switch LH with the 3 screws.
84921A
2.INSTALL RECLINING POWER SEAT SWITCH KNOB
84921B
3.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
71812D
4.INSTALL FRONT SEAT CUSHION SHIELD LH
5.INSTALL FRONT SEAT ASSEMBLY LH