Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234401 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1203/53  ECM Communication Circuit Malfunction  


DESCRIPTION

A new skid control ECU is supplied without engine variation data. Until it is recognized by the ECU, DTC C1203/53 remains stored. By entering test mode, recognition of engine variation data is automatically conducted, and DTC C1203/53 is erased automatically.

DTC Code DTC Detection Condition Trouble Area
C1203/53 When all of following conditions detected:
1.

Engine variation data from ECM does not match one in skid control ECU non-volatile memory.

2.

DTC U0073/94 not detected.

3.

DTC U0100/65 not detected.


·

Test mode not performed

·

Skid control ECU



CAUTION / NOTICE / HINT

NOTICE:

When replacing the VSC actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.PERFORM TEST MODE INSPECTION

NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

b.

Start the engine.


c.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

B