The skid control ECU exchanges signals with the ECM, steering angle sensor, yaw rate and deceleration sensor, power steering ECU, main body ECU and combination meter via CAN communication.
| DTC Code | DTC Detection Conditions | Trouble Area |
|---|---|---|
| U0073/94 | Bus off conditions continue for approximately 0.8 seconds. | CAN communication system |
| U0100/65 | CAN signal from ECM is lost or malfunctioning for 1.2 seconds. | CAN communication system |
| U0114/27 | CAN signal from 4WD control ECU is lost or malfunctioning for 1.2 seconds. | ·
CAN communication system ·
4WD control ECU |
| U0123/62 | Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds. | ·
CAN communication system ·
Yaw rate and deceleration sensor |
| U0124/69 | Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds. | ·
CAN communication system ·
Yaw rate and deceleration sensor |
| U0126/63 | Supplied voltage normal (9.7 V or more), skid control ECU receives no steering angle sensor data for 0.1 seconds. | CAN communication system |
Clear the DTC(s) (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Check if the same DTC(s) is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)