Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234407 YAW RATE AND DECELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 71100S 3.REMOVE CENTER FRONT SEAT ASSEMBLY (for Center Seat)

Hide 58910C 4.REMOVE CONSOLE BOX ASSEMBLY (for Separate Seat Type)

Hide 89183A 5.REMOVE YAW RATE SENSOR

a.

Remove the 2 nuts (labeled A) and sensor.


b.

Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.

U152154E01
1.674,0.708 1.807,0.871 0.133,0.163 10 A 3.501,0.66 3.634,0.823 0.133,0.163 10 A 5.048,0.523 5.181,0.687 0.133,0.163 10 B 5.511,1.122 5.644,1.285 0.133,0.163 10 C