Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TRAILER BRAKE CONTROL SYSTEM
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234409 TRAILER BRAKE CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  TRAILER BRAKE CONTROL SYSTEM  C14A0  Slider Switch Circuit  C14A1  Gain Rocker Switch (+) Circuit  C14A2  Gain Rocker Switch (-) Circuit  C14A3  Type Push Button Switch Circuit  C14A5  Output Circuit Unintended Current  C14A7  ECU Malfunction  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C14A0 When either of following conditions detected:
1.

Manual trailer brake output slider output value continuously exceeds 4.8 V for 30 seconds or more

2.

Manual trailer brake output slider output value is continuously below 0.2 V for 30 seconds or more

3.

Manual trailer brake output slider output value continuously changes faster than physically possible for 0.2 seconds or more


Trailer brake control ECU (Brake control with bracket relay)
C14A1 When either of following conditions detected:
1.

After gain value of 10 (maximum output) is input, GAIN (+) selection button input signal continues for 60 seconds or more

2.

GAIN (+) selection button input signal changes 5 times or more within 0.5 seconds


Trailer brake control ECU (Brake control with bracket relay)
C14A2 When either of following conditions detected:
1.

After gain value of 0 (no trailer brake) is input, GAIN (-) selection button input signal continues for 60 seconds or more

2.

GAIN (-) selection button input signal changes 5 times or more within 0.5 seconds


Trailer brake control ECU (Brake control with bracket relay)
C14A3 When either of following conditions detected:
1.

Trailer brake TYPE selection button input signal continuous for 60 seconds or more

2.

Trailer brake TYPE selection button input signal changes 5 times or more within 0.5 seconds


Trailer brake control ECU (Brake control with bracket relay)
C14A5 When trailer brake control ECU (brake control with bracket relay) is not performing control, output signal continues for 2 seconds or more Trailer brake control ECU (Brake control with bracket relay)
C14A7 When either of following conditions detected:
1.

Trailer brake control ECU (Brake control with bracket relay) internal RAM malfunction

2.

Trailer brake control ECU (Brake control with bracket relay) internal ROM malfunction

3.

Trailer brake control ECU (Brake control with bracket relay) internal EEPROM malfunction

4.

Trailer brake control ECU (Brake control with bracket relay) watchdog (device which monitors whether system is operating normally) malfunction


Trailer brake control ECU (Brake control with bracket relay)

PROCEDURE

1.REPLACE BRAKE CONTROL WITH BRACKET RELAY
a.

Replace the trailer brake control ECU (brake control with bracket relay) (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>TRAILER BRAKE CONTROL ECU>REMOVAL).



NEXT

END