When replacing the trailer brake control ECU, the stored gain value is reset.
Before replacing the trailer brake control ECU, record the set gain value.
After replacing the trailer brake control ECU, the gain value is set to 5.0 (initial value).
55318C
1.REMOVE INSTRUMENT SIDE PANEL LH
67914
2.REMOVE FRONT DOOR SCUFF PLATE LH
for Double Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL)
for CrewMax:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>REMOVAL)
for Regular Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL)
62112
3.REMOVE COWL SIDE TRIM BOARD LH
55046A
4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
55447C
5.REMOVE NO. 2 SWITCH HOLE BASE
89547B
6.REMOVE TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY)
Remove the 2 bolts and trailer brake control ECU (brake control with bracket relay).
Disconnect the connector.