Although the tester title says "Passenger Side", there is only one cool air bypass servo motor on this vehicle.
The cool air bypass servo motor sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the cool air bypass servo motor to any position. As a result, when the air conditioner is operating, the temperature of the air blowing toward the passenger's head area is controlled.
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1445/45 | Cool air bypass servo motor position sensor value does not change even if air conditioning amplifier operates cool air bypass servo motor | ·
Cool air bypass servo motor ·
Air conditioning harness ·
Air conditioning amplifier |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Cool Air Bypass Pulse | Cool air bypass servo motor target pulse /
Min.: 0, Max.: 255 |
Open: 8 (pulse)
Close: 50 (pulse) |
- |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (Checking from the DTC) | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
A
B
C
Temporarily replace the cool air bypass servo motor with a new one (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.
NEXT
Check for DTC (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Replace the air conditioning harness.
NEXT
Check for DTC again (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC is not output.
OK
NG