The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU.
This DTC is output when there is an open or short malfunction in the antenna coil.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2784 | Antenna coil is open/shorted | ·
Harness or connector ·
Transponder key ECU ·
Transponder key amplifier |
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>REGISTRATION).
Clear the DTC (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTC (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC B2784 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Use the Data List to check if the transponder key coil is functioning properly.
| Tester Display | Measurement Item/Display | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Antenna Coil | Antenna coil condition / Normal or Fail | Normal: Antenna coil is normal
Fail: Antenna coil is malfunctioning |
- |
Normal (Antenna coil is normal) appears on the screen.
OK
NG
Disconnect the J26 ECU connector.
Disconnect the J20 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J26-14 (VC5) - J20-1 (VC5) | Always | Below 1 Ω |
| J26-15 (CODE) - J20-4 (CODE) | ||
| J26-4 (TXCT) - J20-5 (TXCT) | ||
| J26-5 (AGND) - J20-7 (AGND) | ||
| J26-14 (VC5) or J20-1 (VC5) - Body ground | Always | 10 kΩ or higher |
| J26-15 (CODE) or J20-4 (CODE) - Body ground | ||
| J26-4 (TXCT) or J20-5 (TXCT) - Body ground | ||
| J26-5 (AGND) or J20-7 (AGND) - Body ground |
OK
NG
Temporarily replace the transponder key amplifier with a new or normally functioning one (see page Vehicle Interior>ENGINE IMMOBILISER>TRANSPONDER KEY AMPLIFIER>REMOVAL).
NEXT
Clear the DTC (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTC (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC B2784 is not output.
OK
NG